TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 481 of 1824
CONTINUITY TEST Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION (10) Install instrument panel assembly (para 7-15). (11) Connect batteries (para 7-57). (1) Disconnect batteries (para 7-57). (2) Remove instrument panel assembly for access (para 7-15). (3) Disconnect connector J31 from connector P31. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to connector J31pin 5. (6) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (7) If continuity is not present, repair wire 3015 from connector J31 pin 5 to terminal board TB2 position 18 on power distribution panel (PDP) (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) If continuity is present, repair wire 3015 from connector P31 socket 5 to terminal lug TL29 (para 2-45) or replace engine control cable assembly (para 7-80). (9) Connect connector J31 to connector P31. TM 9-2320-366-20-1 Change 1 2-315