TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 399 of 1824
Install plastic cable ties as required. (1) Position front grille on cab with washer and screw. (2) Position two washers and screws in front grille. (3) Tighten screw to 48-60 lb-in. (5-7 N.m). (4) Tighten two screws to 24 lb-in. (3 N.m). (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to terminal lug TL48. (7) Connect negative (-) probe of multimeter to terminal lug TL62 and note reading on multimeter. (8) If continuity is not present, go to step 8 of this fault. NOTE CONTINUITY TEST TM 9-2320-366-20-1 Change 1 2-266.3