TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 299 of 1824
VOLTAGE TEST WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. (1) Remove adhesive from solenoid right terminal stud. (2) Connect batteries (para 7-57). (3) Set multimeter to volts DC. (4) Connect positive (+) probe of multimeter to terminal lug TL26. (5) Connect negative (-) probe of multimeter to ground. (6) Lower cab (TM 9-2320-366-10-1). (7) Position master power switch to on (TM 9-2320-366-10-1). (8) Press starter pushbutton (TM 9-2320-366-10-1) and note reading on multimeter. (9) If 24 VDC is not present, go to 4 of this fault. (10) If 24 VDC is present, replace starting motor (para 7-7). (11) Position master power switch to off (TM 9-2320-366-10-1). TM 9-2320-366-20-1 Change 1 2-169