TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 235 of 1824
(1) Remove fuel cap from fuel tank. (2) Apply compressed air to 90° degree fitting on fuel tank and listen for air bubbles in fuel tank. (3) If air flow is not present, replace fuel tank (para 4-8). (4) If air flow is present, replace fuel/water separator (para 4-13). (5) Connect fuel supply hose to fuel tank. (6) Install fuel cap on fuel tank. (1) Disconnect fuel supply hose from fuel/water separator. (2) Disconnect fuel supply hose from fuel tank. (3) Apply compressed air to one end of fuel supply hose. (4) If compressed air does not flow freely through fuel supply hose, replace fuel supply hose (para 4-9). (5) Connect fuel supply hose to fuel/water separator. Compressed air used for cleaning purposes will not exceed 30 psi (207 Kpa). Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to comply may result in injury to personnel. WARNING TM 9-2320-366-20-1 Change 1 2-115