TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 219 of 1824
STE/ICE-R TEST #50 WARNING Diesel fuel is flammable. If fuel is spilled, clean it up immediately. Failure to comply may result in serious injury or death to personnel. TM 9-2320-366-20-1 Change 1 2-108.7/(2-108.8 Blank) (1) Remove plug from tee fitting on outlet side of fuel filter base. (2) Remove adapter fitting from tee fitting on inlet side of fuel filter base. (3) Install plug in tee fitting on inlet side of fuel filter base. (4) Install adapter fitting in tee fitting on outlet side of fuel filter base. (5) Prepare STE/ICE-R Test #50 (TM 9-4910-571-12&P) to adapter fitting. (6) Start engine (TM 9-2320-366-10-1). (7) Perform STE/ICE-R Test #50 (TM 9-4910- 571-12&P). (8) Raise idle speed to 2000 rpm for 10 seconds. (9) Pressure should read between 39 psi and 58 psi. (10) Record test results. (11) Shut down engine (TM 9-2320-366-10-1). (12) If test results indicate more than 10 psi pressure difference from results of step 5 of this fault, replace fuel filter (para 4-14). (13) Disconnect STE/ICE-R from adapter fitting. (14) Remove adapter fitting and preformed packing from tee fitting. Discard preformed packing. (15) Remove plug and preformed packing from tee fitting on inlet side of fuel filter base. Discard preformed packing. (16) Install preformed packing, adapter fitting, and plug in tee fitting on inlet side of fuel filter base. (17) Install preformed packing and plug in tee fitting on outlet side of fuel filter base. (18) Lower cab (TM 9-2320-366-10-1).