TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1501 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING CONTINUITY TEST (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to connector J106-E. (3) Connect negative (-) probe of multimeter to ground. (4) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (5) If 12 vdc is not present, repair wire 1802 (para 2-45) or replace start and charging cable assembly (para 7-132). (6) Position master power switch to off (TM 9-2320-366-10-1). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J106-B. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3029 (para 2-45) or replace start and charging cable assembly (para 7-132). 2-937 2-937 2-937 2-937 2-937