TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1497 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-933 2-933 2-933 2-933 2-933 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Remove kick panel (para 16-3). (2) Disconnect connector P99 from connector J99. (3) Set multimeter to volts dc. (4) Connect positive (+) probe of multimeter to connector P99-1. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (7) If 24 vdc is not present, repair wire 1803 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) If 24 vdc is present, repair wire 1803 (para 2-45) or replace chemical alarm kit cable assembly (para 7-59). (9) Position master power switch to off (TM 9-2320-366-10-1). (10) Connect connector P99 to connector J99. (11) Install kick panel (para 16-3).