TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1487 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-923 2-923 2-923 2-923 2-923 CONTINUITY TEST VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to PDP, terminal 85, where relay K32 was removed. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3036 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to PDP, terminal 30, where relay K32 was removed. (3) Connect negative (-) probe of multimeter to ground. (4) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (5) If 24 vdc is not present, repair wire 26 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (6) Position master power switch to off (TM 9-2320-366-10-1).