TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1485 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-921 2-921 2-921 2-921 2-921 CONTINUITY TEST VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect connector P18 from turn signal switch connector. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to turn signal switch connector terminal 4. (5) Connect negative (-) probe of multimeter to turn signal switch connector terminal 12. (6) Press horn button (TM 9-2320-366-10-1) and note reading on multimeter. (7) If continuity is not present, replace turn signal switch (para 7-26). (8) Connect connector P18 to turn signal switch connector. (9) Install instrument panel assembly (para 7-15). (1) Remove PDP cover (para 16-2). (2) Remove relay K32 from PDP. (3) Set multimeter to volts dc. (4) Connect positive (+) probe of multimeter to PDP, terminal 86, where relay K32 was removed. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9-2320-366-10-1). (7) Press horn button (TM 9-2320-366-10-1) and note reading on multimeter. (8) If 24 vdc is not present, repair wire 25 (para 2-45) or WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) Position master power switch to off (TM 9-2320-366-10-1).