TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1463 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-899 2-899 2-899 2-899 2-899 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (1) Disconnect connector J2 from connector P2. (2) Set multimeter to volts dc. (3) Connect positive (+) probe of multimeter to connector J2-2. (4) Connect negative (-) probe of multimeter to ground. (5) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 24 vdc is not present, repair wire 1569 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (7) If 24 vdc is present, replace windshield wiper EMI cable (para 7-68). (8) Position master power switch to off (TM 9-2320-366-10-1). (9) Connect connector P2 to connector J2. (10) Install PDP on dashboard with three screws. (11) Install three washers and screws in PDP. (12) Install PDP cover (para 16-2). CONTINUITY TEST (1) Disconnect connector J2 from connector P2. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector J2-3. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3037 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (6) If continuity is present, replace windshield wiper EMI cable (para 7-68). (7) Connect connector P2 to connector J2. (8) Install PDP on dashboard with three screws. (9) Install three washers and screws in PDP. (10) Install PDP cover (para 16-2).