TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1461 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-897 2-897 2-897 2-897 2-897 CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector PX22-1. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, go to step 5 of this fault. (5) Connect connector PX22 to windshield wiper motor. CONTINUITY TEST (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect turn signal switch connector from connector P18. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to turn signal switch connector terminal 6. (5) Connect negative (-) probe of multimeter to turn signal switch connector terminal 4. (6) Position windshield wiper switch to high (TM 9-2320-366-10-1) and note reading on multimeter. (7) If continuity is not present, replace turn signal switch (para 7-26). (8) If continuity is present, replace windshield wiper motor (para 18-4). (9) Position windshield wiper switch to off (TM 9-2320-366-10-1). (10) Connect turn signal switch connector to connector P18. (11) Install instrument panel assembly (para 7-15). (12) Install PDP on dashboard with three screws. (13) Install three washers and screws in PDP. (14) Install PDP cover (para 16-2).