TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1453 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-889 2-889 2-889 2-889 2-889 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING NOTE 24 vdc is indicated for approximately 1 (one) second. CONTINUITY TEST (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to connector PX22-2. (3) Connect negative (-) probe of multimeter to ground. (4) Position master power switch to on (TM 9-2320-366-10-1). (5) Position windshield wiper switch to low (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 24 vdc is not present, go to step 5 of this fault. (7) Position windshield wiper switch to off (TM 9-2320-366-10-1). (8) Position master power switch to off (TM 9-2320-366-10-1). (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect turn signal switch connector from connector P18. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to turn signal switch connector terminal 4. (5) Connect negative (-) probe of multimeter to turn signal switch connector terminal 5. (6) Position windshield wiper switch to low position (TM 9-2320-366-10-1) and note reading on multimeter. (7) If continuity is not present, replace turn signal switch (para 7-26). (8) Position windshield wiper switch to off (TM 9-2320-366-10-1). (9) Connect turn signal switch connector to connector P18. (10) Install instrument panel assembly (para 7-15).