TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1451 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-887 2-887 2-887 2-887 2-887 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Remove PDP cover (para 16-2). (2) Remove three screws and washers from PDP. (3) Remove three screws from PDP. (4) Lift PDP outward to gain access. (5) Disconnect connector PX22 from windshield wiper motor. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter to connector PX22-5. (8) Connect negative (-) probe of multimeter to ground. (9) Position master power switch to on (TM 9-2320-366-10-1). (10) Position windshield wiper switch to low (TM 9-2320-366-10-1) and note reading on multimeter. (11) If 24 vdc is not present, go to step 3 of this fault. (12) Position windshield wiper switch to off (TM 9-2320-366-10-1). (13) Position master power switch to off (TM 9-2320-366-10-1).