TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1445 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-881 2-881 2-881 2-881 2-881 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. CONTINUITY TEST VOLTAGE TEST (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect connector P18 from turn signal switch connector. (3) Set multimeter to volts dc. (4) Connect positive (+) probe of multimeter to connector P18-4. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9-2320-366-10-1). (7) Press windshield washer switch (TM 9-2320-366-10-1) and note reading on multimeter. (8) If 24 vdc is not present, repair wire 1569 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) Position master power switch to off (TM 9-2320-366-10-1). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to turn signal switch connector terminal 4. (3) Connect negative (-) probe of multimeter to turn signal switch connector terminal 8. (4) Press windshield washer switch (TM 9-2320-366-10-1) and note reading on multimeter. (5) If continuity is not present, replace turn signal switch (para 7-26). (6) Connect connector P18 to turn signal switch connector. (7) Install instrument panel assembly (para 7-15).