TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1431 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-867 2-867 2-867 2-867 2-867 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (13) Connect connector PX25 to personnel heater connector. (14) Install personnel heater (para 18-8). (8) Position dimmer switch to maximum brightness (TM 9-2320-366-10-1) and note reading on multimeter. (9) If 12 vdc is not present, repair wire 1908 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (10) If 12 vdc is present, replace or repair personnel heater (para 18-9). (11) Position master power switch to off (TM 9-2320-366-10-1). (12) Position main light switch auxiliary lever to OFF (TM 9-2320-366-10-1). (1) Remove personnel heater for access (para 18-9). (2) Disconnect connector PX25 from personnel heater connector. (3) Set multimeter to volts dc. (4) Connect positive (+) probe of multimeter to connector PX25-1. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9-2320-366-10-1). (7) Position main light switch auxiliary lever to PNL BRT (TM 9-2320-366-10-1).