TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1425 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-861 2-861 2-861 2-861 2-861 Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING VOLTAGE TEST NOTE Remove plastic cable ties as required. NOTE Install plastic cable ties as required. (9) Connect connector P52R to connector J52. (1) Disconnect connector P52R from connector J52. (2) Set multimeter to volts dc. (3) Connect positive (+) probe of multimeter to connector P52R-1. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 12 vdc is not present, repair wire 21 (para 2-45) or replace rear lights cable assembly (para 7-84 or 7-104). (7) If 12 vdc is present, replace rear intervehicular 12 vdc (7 pin) cable (para 7-128). (8) Position main light switch to OFF (TM 9-2320-366-10-1).