TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1415 of 1824
TM 9-2320-366-20-1 VOLTAGE TEST Change 1 2-851 Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. WARNING NOTE Remove plastic cable ties as required. Install plastic cable ties as required. NOTE (1) Disconnect connector P52R from connector J52. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector P52R pin 7. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (6) Position turn signal switch to right turn (TM 9-2320-366-10-1). (7) If 12 VDC pulse is not present, repair wire 460B from connector P51 socket 11 to connector P52R pin 7 (para 2-45) or replace rear lights cable assembly (para 7-84 or 7-104). (8) If 12 VDC pulse is present, replace rear intervehicular 12 VDC (7 pin) cable (para 7-128). (9) Position turn signal switch to off (TM 9-2320-366-10-1). (10) Position main light switch to OFF (TM 9-2320-366-10-1). (11) Connect connector P52R to connector J52.