TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1407 of 1824
TM 9-2320-366-20-1 Change 1 2-843 CAUTION NOTE WARNING VOLTAGE TEST (1) Remove PDP cover (para 16-2). (2) Remove three screws and washers from PDP. (3) Remove three screws from PDP. (4) Lift PDP outward to gain access. (5) Disconnect connector J51 from connector P51. (6) Set multimeter to volts DC. (7) Connect positive (+) probe of multimeter to connector J51 pin 12. (8) Connect negative (-) probe of multimeter to ground. (9) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (10) Position turn signal switch to left turn (TM 9-2320-366-10-1) and note reading on multimeter. (11) If 12 VDC pulse is not present, repair wire 461B from connector J51 pin 12 to splice E3. (12) Position main light switch to OFF (TM 9-2320-366-10-1). (13) Position turn signal switch to off (TM 9-2320-366-10-1). (14) Connect connector J51 to connector P51. (15) Install PDP on dashboard with three screws. (16) Install three washers and screws in PDP. (17) Install PDP cover (para 16-2). Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock.