TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1391 of 1824
TM 9-2320-366-20-1 WARNING CAUTION Change 1 2-827 (1) Lift cover on connector J130 intervehicular 24 VDC connector. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector J130 socket F. (4) Connect negative (-) probe of multimeter to ground. (5) Position master power switch to on (TM 9-2320-366-10-1). (6) Position main light switch to BO DRIVE (TM 9-2320-366-10-1). (7) Apply brakes and note reading on multimeter. (8) If 24 VDC is not present, go to step 2 of this fault. (9) If 24 VDC is present, troubleshoot trailer electrical system per trailer technical manual. (10) Position main light switch to OFF (TM 9-2320-366-10-1). (11) Position master power switch to off (TM 9-2320-366-10-1). Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. VOLTAGE TEST