TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1375 of 1824
TM 9-2320-366-20-1 Change 1 2-811 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. VOLTAGE TEST (1) Set multimeter to volts DC. (2) Connect positive (+) probe of multimeter to relay K30 terminal 86 on PDP. (3) Connect negative (-) probe of multimeter to ground. (4) Position master power switch to on (TM 9-2320-366-10-1). (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (6) Apply brakes and note reading on multimeter. (7) If 12 VDC is not present, repair wire 461B from relay K30 terminal 86 on PDP to connector J19 socket 2 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) Position main light switch to OFF (TM 9-2320-366-10-1). (9) Position master power switch to off (TM 9-2320-366-10-1). CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to relay K30 terminal 85 on PDP. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3047 from K30 terminal 85 on PDP to terminal board TB2 position 50 (para 2-45) or replace WTEC II dashboard assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (5) If continuity is present, replace relay K30 (para 7-9). (6) Install relay K30 in PDP. (7) Install PDP cover (para 16-2).