TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1345 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-781 2-781 2-781 2-781 2-781 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (1) Remove circuit breaker CB76 from PDP. (2) Set multimeter to volts dc. (3) Connect positive (+) probe of multimeter to PDP, terminal 3, where circuit breaker CB76 was removed. (4) Connect negative (-) probe of multimeter to ground. (5) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 12 vdc is not present, repair wire 1548 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (7) If 12 vdc is present, repair wire 1641 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) Position master power switch to off (TM 9-2320-366-10-1). (9) Install circuit breaker CB76 in PDP. (10) Install relay K6 in PDP. (11) Install PDP cover (para 16-2).