TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1321 of 1824
TM 9-2320-366-20-1 Change 1 2-758.1 NOTE CONTINUITY TEST (1) Disconnect turn signal switch connector from connector J19. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to PDP, terminal 30, where relay K10 was removed. (4) Connect negative (-) probe of multimeter to connector J19 socket 6. (5) If continuity is not present, repair wire 1594 from relay K10 terminal 30 to connector J19 socket 6 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (6) If continuity is present, replace relay K10 (para 7-9). (7) Connect connector J19 to turn signal switch connector. (8) Install instrument panel assembly (para 7-15). (9) Install relay K10 in PDP. (10) Install PDP cover (para 16-2). Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION