TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1281 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-727 2-727 2-727 2-727 2-727 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (1) Remove PDP cover (para 16-2). (2) Remove circuit breaker CB74 from PDP. (3) Set multimeter to volts dc. (4) Connect positive (+) probe of multimeter to PDP, terminal 5, where circuit breaker CB74 was removed. (5) Connect negative (-) probe of multimeter to ground. (6) Position main light switch to STOPLIGHT (TM 9-2320-366-10-1) and note reading on multimeter. (7) If 12 vdc is not present, repair wire 1577 (para 2-45 )or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) Position main light switch to OFF (TM 9-2320-366-10-1). (9) Install circuit breaker CB74 in PDP. (10) Install PDP cover (para 16-2).