TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1271 of 1824
VOLTAGE TEST VOLTAGE TEST TM 9-2320-366-20-1 Change 1 2-717/(2-718 Blank) All data on pages 2-718 and 2-719 deleted. WARNING (1) Remove PDP cover (para 16-2). (2) Remove circuit breaker CB71 from PDP. (3) Remove relay K9 from PDP. (4) Set multimeter to volts DC. (5) Connect positive (+) probe of multimeter to PDP, terminal 30, where relay K9 was removed. (6) Connect negative (-) probe of multimeter to ground. (7) Install circuit breaker CB71 in PDP and and note reading on multimeter. (8) If 12 VDC is not present, repair wire 1566 from relay K9 terminal 30 to circuit breaker CB 71 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (1) Set multimeter to volts DC. (2) Connect positive (+) probe of multimeter to PDP, terminal 86, where relay K9 was removed. (3) Connect negative (-) probe of multimeter to ground. (4) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and not reading on multimeter. (5) If 12 VDC is not present, repair wire 1514 from relay K9 terminal 86 to circuit breaker CB74 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (6) Position main light switch to OFF (TM 9-2320-366-10-1). Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock.