TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1253 of 1824
CAUTION CONTINUITY TEST Change 1 2-699 TM 9-2320-366-20-1 NOTE (1) Remove kick panel (para 16-3). (2) Disconnect connector clamp from connector P115. (3) Disconnect connector P115 from WTEC III transmission ECU. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to PDP, where WTEC III relay K25 terminal 85 was removed. (6) Connect negative (-) probe of multimeter to connecter P115 socket 4 and note reading on multimeter. (7) If continuity is not present, repair wire 113 from WTEC III relay K25 terminal 85 to connector P115 socket 4 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). (8) Connect connector P115 to WTEC III transmission ECU. (9) Connect connector clamp to connector P115. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment.