TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1211 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-657 2-657 2-657 2-657 2-657 Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING VOLTAGE TEST (13) Connect connector P65 to connector J65. (14) Install kick panel (para 16-3). (1) Remove seven screws and washers from kick panel. (2) Remove kick panel and stiffener from dashboard. (3) Disconnect connector P65 from connector J65. (4) Set multimeter to volts dc. (5) Connect positive (+) probe of multimeter to connector J65-1. (6) Connect negative (-) probe of multimeter to ground. (7) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (8) Position warning light switch to on (TM 9-2320-366-10-1). (9) If 12 vdc is not present, repair wire 509 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (10) If 12 vdc is present, repair wire 509 (para 2-45) or replace warning light cable assembly (para 22-5). (11) Position warning light switch to off (TM 9-2320-366-10-1). (12) Position main light switch to OFF (TM 9-2320-366-10-1).