TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1209 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-655 2-655 2-655 2-655 2-655 Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING VOLTAGE TEST VOLTAGE TEST (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to PDP, socket 30, where relay K13 was removed. (3) Connect negative (-) probe of multimeter to ground. (4) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (5) Position warning light switch to on (TM 9-2320-366-10-1). (6) If 12 vdc is not present, repair wire 509 (para 2-45)or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (7) Position warning light switch to off (TM 9-2320-366-10-1). (8) Position main light switch to OFF (TM 9-2320-366-10-1). (1) Install relay K13 in PDP. (2) Set multimeter to volts dc. (3) Connect positive (+) probe of multimeter to relay K13 terminal 87. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (6) Position warning light switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (7) If 12 vdc is not present, replace relay K13 (para 7-9). (8) Position warning light switch to off (TM 9-2320-366-10-1). (9) Position main light switch to OFF (TM 9-2320-366-10-1).