TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1115 of 1824
Change 1 2-604.183 TM 9-2320-366-20-1 CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL32, and lockwasher from RH rear marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL31. (4) Connect negative (-) probe of multimeter to terminal lug TL32 and note reading on multimeter. (5) If continuity is not present, repair wire 3094 from terminal TL31 to terminal lug TL32 (para 2-45) and go to step 3 of this fault if required or replace M1088 rear lights cable assembly (para 7-104) and go to step 1 of this fault. (6) If continuity is present, replace LH rear marker light (para 7-38) and go to step 3 of this fault if required. (7) Install lockwasher, terminal lug TL31, lockwasher, and nut on middle rear marker light screw. (8) Install lockwasher, terminal lug TL32, lockwasher, and nut on RH rear marker light screw.