TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1113 of 1824
CONTINUITY TEST Change 1 2-604.181 TM 9-2320-366-20-1 (9) Install lens cover on LH rear marker light base with two screws. (1) Remove nut, lockwasher, terminal lug TL30, and lockwasher from LH rear marker light screw. Discard lockwashers. (2) Remove nut, lockwasher, terminal lug TL31, and lockwasher from middle rear marker light screw. Discard lockwashers. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to terminal lug TL30. (5) Connect negative (-) probe of multimeter to terminal lug TL31 and note reading on multimeter. (6) If continuity is not present, repair wire 3094 from terminal TL30 to terminal lug TL31 (para 2-45) and go to step 3 of this fault if required or replace M1088 rear lights cable assembly (para 7-104) and go to step 1 of this fault. (7) Install lockwasher, terminal lug TL30, lockwasher, and nut on LH rear maker light screw. (8) Install LH rear marker light lamp in socket.