TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1105 of 1824
CONTINUITY TEST Change 1 2-604.173 TM 9-2320-366-20-1 (1) Disconnect connector P52M from connector J52M. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector P51 socket 7. (4) Connect negative (-) probe of multimeter to connector P52M socket 3 and note reading on multimeter. (5) If continuity is not present, repair wire 489 from connector P51 socket 7 to P52M socket 3 or replace M1088 rear lights cable assembly (7-104). (6) Connect connector J52M to connector P52M. (7) Connect connector J51 to connector P51. (8) Install PDP on dashboard with three screws. (9) Install three washers and screws in PDP. (10) Install PDP cover (para 16-2). (11) Connect batteries (para 7-57). Use care when testing electrical connectors not to bend connector pins or damage connector sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE