TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 1093 of 1824

Change 1 2-604.161 TM 9-2320-366-20-1 Remove plastic cable ties as required. (1) Disconnect connector P85 from LH rear side marker light connector. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector P85. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (6) Position main light switch to OFF (TM 9-2320-366-10-1). (7) If 12 VDC is not present, repair wire 489 from splice E15 to splice E16 (para 2-45) and go to step 46 of this fault if required or replace M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. VOLTAGE TEST NOTE WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits, or cause severe burns or electrical shock. Use care when testing electrical connectors not to bend connector pins or damage connector sockets wo multimeter probes. Failure to comply may result in damage to equipment. CAUTION Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE (8) If 12 VDC is present, repair wire 489 from connector P85 to splice E16 (para 2-45) and go to step 46 of this fault if required or replace M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of of this fault. Install plastic cable ties as required. (9) Connect LH rear side marker light connector to connector P85. (10) Connect LH marker light connector to connector P86. NOTE