TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1091 of 1824
CONTINUITY TEST Change 1 2-604.159 TM 9-2320-366-20-1 (1) Remove nut, lockwasher, terminal lug TL20, and lockwasher from RH rear marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL20. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3095 from terminal lug TL20 to terminal lug TL21 (para 2-45) and go to step 9 of this fault if required or replace M1085/ M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace RH rear marker light (para 7-38) and go to step 9 of this fault if required. (7) Install lockwasher, terminal lug TL20, lockwasher, and nut on RH rear marker light screw. (8) Connect RH rear marker light connector to connector P89.