Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 1087 of 1824

Change 1 2-604.155 TM 9-2320-366-20-1 CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL16, and lockwasher from LH rear marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL16. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3094 from terminal lug TL16 to terminal lug TL18 (para 2-45) and go to step 46 of this fault if required or replace M1085/ M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace LH rear marker light (para 7-38) and go to step 46 of this fault if required. (7) Install lockwasher, terminal lug TL16, lockwasher, and nut on LH rear marker light screw. (8) Connect LH rear marker light connector to connector P86.