TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1083 of 1824
CONTINUITY TEST Change 1 2-604.151 TM 9-2320-366-20-1 CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL30, and lockwasher from LH rear marker light screw. Discard lockwashers. (2) Remove nut, lockwasher, terminal lug TL31, and lockwasher from middle rear marker light screw. Discard lockwashers. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to terminal lug TL30. (5) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (6) If continuity is not present, repair wire 3094 from terminal lug TL30 to terminal lug TL31 (para 2-45) and go to step 11 of this fault if required or replace M1086 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (7) Install lockwasher, terminal lug TL30, lockwasher, and nut on LH rear marker light screw. (1) Remove nut, lockwasher, terminal lug TL32, and lockwasher from RH rear marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL31. (4) Connect negative (-) probe of multimeter to terminal lug TL32 and note reading on multimeter. (5) If continuity is not present, repair wire 3094 from terminal lug TL31 to terminal lug TL32 (para 2-45) and go to step 11 of this fault if required or replace M1086 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace LH rear marker light (para 7-38) and go to step 11 of this fault if required. (7) Install lockwasher, terminal lug TL32, lockwasher, and nut on RH rear marker light screw. (8) Install lockwasher, terminal lug TL31, lockwasher, and nut on middle rear marker light screw.