Sign up to sell your inventory with NSN Lookup

TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 1081 of 1824

Change 1 2-604.149 TM 9-2320-366-20-1 CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL19, and lockwasher from RH side marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL19. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3095 from terminal lug TL19 to terminal lug TL20 (para 2-45) and go to step 9 of this fault if required or replace M1086/ M1089 rear lights cable assembly (para 7-104) or M1086/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace RH side marker light (para 7-38) and go to step 9 of this fault if required. (7) Install lockwasher, terminal lug TL19, lockwasher, and nut on RH side marker light screw. (8) Connect RH side marker light connector to connector P88.