TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 1067 of 1824

Change 1 2-604.135 TM 9-2320-366-20-1 CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL16, and lockwasher from LH rear marker light screw. Discard lockwashers. (2) Step multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL16. (4) Connect negative probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair 3094 from terminal lug TL16 to terminal lug TL18 (para 2-45) and go to step 8 of this fault if required or replace M1086/M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. Table 2-12.12. M1085/M1086/M1089/M1096 LH Rear Marker Light Splices M1085/M1086/M1096 M1089 E15 E16 E49 E51 Model Splice "A" Splice "B" (6) If continuity is present, repair 489 from splice "A" to splice "B" (refer to Table 2-12.12. M1085/M1086/M1089/M1096 LH Rear Marker Light Splices) (para 2-45) and go to step 8 of this fault if required or replace M1086/M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (7) Install lockwasher, terminal lug TL16, lockwasher, and nut on LH rear marker light screw.