TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1061 of 1824
Change 1 2-604.129 TM 9-2320-366-20-1 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits, or cause severe burns or electrical shock. CAUTION VOLTAGE TEST Table 2-12.11. M1085/M1086/M1089/M1096 Rear Marker Light Splices Model Splice M1085/M1086/M1096 E15 M1089 E50 (1) Disconnect middle rear marker light connector from connector P56. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector P56. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (6) Position main light switch to OFF (TM 9-2320-366-10-1). (7) If 12 VDC is not present, repair wire 489 from connector P56 to splice (refer to Table 2-12.11. M1085/M1086/M1089/M1096 Rear Marker Lights Splices) (para 2-45) and go to step 12 of this fault if required or replace M1086/M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (8) Connect middle rear marker light connector to connector P56. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors not to bend connector pins or damage connector sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE