TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1043 of 1824
M1085/M1086/M1096 M1089 E16 E51 Change 1 2-604.111 TM 9-2320-366-20-1 Model Splice Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits, or cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors not to bend connector pins or damage connector sockets with multimeter probes. Failure to comply may result in damage to equipment. (1) Disconnect LH rear marker light connector from connector P86. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector P86. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (6) Position main light switch to OFF (TM 9-2320-366-10-1). (7) Is 12 VDC is not present, repair wire 489 from connector P86 to splice (refer to Table 2-12.8. M1085/M1086/M1089/ M1096 LH Side And Rear Marker Lights Splices) (para 2-45) and go to step 8 of this fault if or replace M1086/M1089 rear lights cable assembly (para 7-104) or M1085/ M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (8) If 12 VDC is present, replace LH rear marker light (para 7-38) and go to step 8 of this fault if required. VOLTAGE TEST (9) Connect LH rear marker light connector to connector P86. Table 2-12.8. M1085/M1086/M1089/M1096 LH Side and Rear Marker Light Splices