TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1035 of 1824
CONTINUITY TEST Change 1 2-604.103 TM 9-2320-366-20-1 (7) Install lockwasher, terminal lug TL89, lockwasher, and nut on RH intermediate marker light screw. (8) Connect RH intermediate marker light connector to connector P95. (1) Remove nut, lockwasher, terminal lug TL89, and lockwasher from RH intermediate marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL89. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3090 from terminal lug TL89 to terminal lug TL90 (para 2-45) and go to step 6 of this fault if required or replace M1086/ M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace RH intermediate marker light (para 7-38) and go to step 6 of this fault if required.