TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1031 of 1824
TM 9-2320-366-20-1 Change 1 2-604.99 CONTINUITY TEST CONTINUITY TEST (8) Connect LH intermediate marker light connector to connector P94. (1) Remove two screws and lens cover from RH intermediate marker light base. (2) Remove RH intermediate marker light lamp from socket. (3) Set multimeter to ohms. (4) Check continuity through RH intermediate marker light lamp and note reading on multimeter. (5) If continuity is not present, replace RH intermediate marker light lamp (para 7-38) and go to step 6 of this fault if required. (6) Install RH intermediate marker light lamp in socket. (7) Install lens cover on RH intermediate marker light base with two screws. (1) Remove nut, lockwasher, terminal lug TL88, and lockwasher from LH intermediate marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL88. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3089 from terminal lug TL88 to terminal lug TL90 (para 2-45) and go to step 5 of this fault if required or replace M1086/ M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace LH intermediate marker light (para 7-38) and go to step 5 of this fault if required. (7) Install lockwasher, terminal lug TL88, lockwasher, and nut on LH intermediate marker light screw.