Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 1025 of 1824

TM 9-2320-366-20-1 Change 1 2-604.93 CONTINUITY TEST Marker Light LH Intermediate LH Side LH Rear Left Rear Middle Rear Right Rear RH Rear RH Side RH Intermediate TL19 TL20 TL32 TL31 TL30 TL16 TL15 TL88 Terminal Lug M1089 TL89 M1085/M1086/M1096 Wire 3089 from Terminal Lug TL88 to Terminal Lug TL90 Wire 3094 from Terminal Lug TL15 to Terminal Lug TL16 Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Wire 3094 from Terminal Lug TL32 to Terminal Lug TL31 Wire 3095 from Terminal Lug TL19 to Terminal Lug TL20 Wire 3090 from Terminal Lug TL89 to Terminal Lug TL90 Wire 3090 from Terminal Lug TL89 to Terminal Lug TL90 Wire 3095 from Terminal Lug TL19 to Terminal Lug TL20 Wire 3094 from Terminal Lug TL30 to Terminal Lug TL31 Wire 3094 from Terminal Lug TL15 to Terminal Lug TL16 Wire 3089 from Terminal Lug TL88 to Terminal Lug TL90 Table 2-12.5. M1085/M1086/M1089/ M1096 Intermediate, Side, and Rear Marker Light Terminal Lugs (8) Connect marker light connector to connector (refer to Table 2-12.5. M1085/ M1086/ M1089/M1096 Intermediate, Side, and Rear Marker Light Terminal Lugs). (1) Remove nut, lockwasher, terminal lug, and lockwasher from marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug (refer to Table 2-12.5. M1085/M1086/ M1089/M1096 Intermediate, Side, and Rear Marker Light Terminal Lugs). (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire (Refer to Table 2-12.5. M1085/M1086/ M1089/ M1096 Intermediate, Side, and Rear Marker Light Terminal Lugs) (para 2-45) or replace M1086/M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84). (6) If continuity is present, replace marker light (para 7-38). (7) Install lockwasher, terminal lug, lockwasher, and nut on marker light screw.