TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 1023 of 1824
TM 9-2320-366-20-1 Change 1 2-604.91 M1089 Splice M1085/M1086 /M1096 Splice Connector Marker Light P95 RH Side RH Rear Right Rear Middle Rear Left Rear LH Rear LH Side LH Intermediate P94 P85 P86 P54 P56 P58 P89 P88 RH Intermediate Table 2-12.4. M1085/M1086/M1089/M1096 Intermediate, Side, and Rear Marker Light Connectors and Splices Splice E64 Splice E16 Splice E16 Splice E15 Splice E15 Splice E15 Splice E17 Splice E17 Splice E64 Splice E51 Splice E51 Splice E49 Splice E49 Splice E50 Splice E50 Splice E50 Splice E52 Splice E52 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits, or cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors not to bend connector pins or damage connector sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. VOLTAGE TEST (1) Disconnect marker light connector from connector (refer to Table 2-12.4. M1085/ M1086/M1089/M1096 Intermediate, Side, and Rear Marker Light Connectors and Splices). (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector (refer to Table 2-12.4. M1085/M1086/M1089/M1096 Intermediate, Side, and Rear Marker Light Connectors and Splices). (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (6) Position main light switch to OFF (TM 9-2320-366-10-1). (7) If 12 VDC is not present, repair wire 489 (refer to Table 2-12.4. M1085/M1086/ M1089/M1096 Intermediate, Side, and Rear Marker Light Connectors and Splices) (para 2-45) or replace M1086/M1089 rear lights cable assembly (para 7-104) or M1085/M1096 rear lights cable assembly (para 7-84).