TM-9-2320-366-10-2 MTV Operator Manual M1083 Series - Volume 2 Download
Page 582 of 930
TM 9-2320-366-10-2 Table 3-2. Troubleshooting (Cont) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION f. TRANSMISSION SYSTEM (CONT) f4. WTEC III TRANSMISSION PUSHBUTTON SHIFT SELECTOR (TPSS) DOES NOT ILLUMINATE (CONT). (b) Position master power switch to off (para 2-27f). (c) If circuit breaker(s) is tripped, push in to reset. (d) Position master power switch to on (para 2-27a or b). (e) Check circuit breakers in PDP to see if they tripped again. If circuit breakers tripped again, notify Unit Maintenance. (f) Position master power switch to off (para 2-27f). (g) Install PDP cover (para 3-17b). (h) If WTEC III TPSS still does not illuminate, notify Unit Maintenance. g. PROPELLER SHAFT g1. PROPELLER SHAFTS OR UNIVERSAL JOINTS UNUSUALLY NOISY WHEN OPERATING. Notify Unit Maintenance. h. POWER TAKE OFF (PTO) h1. POWER TAKE-OFF (PTO) DOES NOT ENGAGE. Notify Unit Maintenance. i. BRAKE SYSTEM i1. EXCESSIVE BRAKING DISTANCE. Check to see if air tanks are pressurized. (a) Start engine (para 2-27a or b). (b) Allow engine to idle until 120 psi is registered on FRONT BRAKE AIR and REAR BRAKE AIR pressure gages. (c) Shut down engine (para 2-27f). (d) If either FRONT BRAKE AIR or REAR BRAKE AIR pressure gages do not register 120 psi, notify Unit Maintenance. (e) If braking distance is still excessive, notify Unit Maintenance. i2. REAR BRAKES DO NOT APPLY. Check to see if air tanks are pressurized. (a) Start engine (para 2-27a or b). 3-82 Change 1