TM-9-2320-366-10-2 MTV Operator Manual M1083 Series - Volume 2 Download
Page 580 of 930
TM 9-2320-366-10-2 Table 3-2. Troubleshooting (Cont) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION e. ELECTRICAL SYSTEM (CONT) e145. M1088/M1089 WORKLIGHTS DO NOT ILLUMINATE (CONT). (e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance. (f) Position master power switch to off (para 2-27f). (g) Install PDP cover (para 3-17b). (h) If worklights still do not illuminate, notify Unit Maintenance. e146. M1088/M1089 (LH) WORKLIGHT DOES NOT ILLUMINATE. Notify Unit Maintenance. e147. M1088/M1089 (RH) WORKLIGHT DOES NOT ILLUMINATE. Notify Unit Maintenance. e148. M1088/M1089 WORKLIGHTS DO NOT ILLUMINATE IN BLACKOUT MODE WITH BLACKOUT OVERRIDE SWITCH ON. Notify Unit Maintenance. e149. M1084/M1086 WORKLIGHTS DO NOT ILLUMINATE. Check circuit breaker (CB72) in PDP to see if it is tripped. (a) Remove PDP cover (para 3-17a). (b) Position master power switch to off (para 2-27f). (c) If circuit breaker is tripped, push in to reset. (d) Position master power switch to on (para 2-27a or b). (e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance. (f) Position master power switch to off (para 2-27f). (g) Install PDP cover (para 3-17b). (h) If worklights still do not illuminate, notify Unit Maintenance. f. TRANSMISSION SYSTEM f1. WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) EMITS EIGHT SECONDS OF BEEPS AND/OR TRANSMISSION DOES NOT SHIFT GEARS. Notify Unit Maintenance. 3-80 Change 1