TM-9-2320-366-10-2 MTV Operator Manual M1083 Series - Volume 2 Download
Page 546 of 930
TM 9-2320-366-10-2 Table 3-2. Troubleshooting (Cont) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION e. ELECTRICAL SYSTEM (CONT) e25. LEFT TURN SIGNAL INDICATOR DOES NOT ILLUMINATE. Step 1. Check operation of turn signals (para 2-18, item 21). If turn signals do not illuminate, go to step 2. If turn signals are OK, notify Unit Maintenance. Step 2. Check for illumination of high beams on indicator (para 2-27c). If high beam indicator does not illuminate, perform Electrical System Troubleshooting (e27 Turn Signal Indicator and High Beam Indicator Do Not Illuminate). Step 3. Check circuit breaker (CB74) in PDP to see if it is tripped. (a) Remove PDP cover (para 3-17a). (b) Position main light switch to OFF (para 2-27c). (c) If circuit breaker is tripped, push in to reset. (d) Position main light switch to SER DRIVE (para 2-27c). (e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance. (f) Position main light switch to OFF (para 2-27c). (g) Install PDP cover (para 3-17b). (h) If left turn signal indicator still does not illuminate, notify Unit Maintenance. e26. RIGHT TURN SIGNAL INDICATOR DOES NOT ILLUMINATE. Step 1. Check operation of turn signals (para 2-18, item 21). If turn signals do not illuminate, go to step 2. If turn signals are OK, notify Unit Maintenance. Step 2. Check circuit breaker (CB74) in PDP to see if it is tripped. (a) Remove PDP cover (para 3-17a). (b) Position main light switch to OFF (para 2-27c). (c) If circuit breaker is tripped, push in to reset. (d) Position main light switch to SER DRIVE (para 2-27c). (e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance. (f) Position main light switch to OFF (para 2-27c). 3-46 Change 1