TM-9-2320-366-10-1 MTV Operator Manual M1083 Series - Volume 1 Download
Page 726 of 802
TM 9-2320-366-10-1 F-2 Change 2 F-1. GENERAL (CONT) c. Lubrication After Fording. If a fording operation occurs, lubricate all fittings below fording depth and check submerged gear boxes for presence of water. d. Lubrication After High-Pressure Washing. After a thorough washing, lubricate all grease fittings and oil can points outside and underneath vehicle. e. Lubrication Local Views. A reference to the appropriate localized view is given after most lubrication entries. Lubrication local views begin on page F-10. F-2. CORROSION CONTROL Refer to para 1-3 for appropriate corrosion control procedures. F-3. AOAP SAMPLING INTERVAL Engine/transmission oil must be sampled every 90 days as prescribed by DA Pam 738- 750. Hydraulic fluids must be sampled annually as prescribed by DA Pam 738-750. F-4. HARD TIME LUBRICATION INTERVALS For equipment under manufacturer's warranty, hard time oil service intervals shall be followed. Intervals shall be shortened if lubricants are known to be contaminated or if operation is under adverse conditions (e.g. longer than usual operating hours, extended idling periods, extreme dust, etc.). F-5. LUBRICATION/SERVICES KEY LUBRICANTS Specification Type MIL-L-2104 (OE/HDO) Lubricating Oil, Internal Combustion Engine, Combat/Tactical Service MIL-H-5606 (OHA) Hydraulic Fluid, Petroleum Base, Aircraft, Missile, and Ordnance MIL-G-10924 (GAA) Grease, Automotive and Artillery V-V-D-1078 Damping Fluid