TM-9-2320-366-10-1 MTV Operator Manual M1083 Series - Volume 1 Download
Page 601 of 802
TM 9-2320-366-10-1 Change 2 2-383 b. Raising Cab Protector. Cab protector is spring loaded and weighs approximately 180 lbs (82 kgs). Hold cab protector down before removing pins. Slowly allow cab protector to raise to upright position after pins are removed. Failure to comply may result in injury to personnel. NOTE Left and right sides of cab protector is prepared the same way. Left side shown. (1) Remove lynch pin (1) from hitch pin (2). (2) Remove hitch pin (2) from cab protector (3) and dump body (4). (3) Install hitch pin (2) and lynch pin (1) in cab protector (3). (4) Remove lynch pin (5) and turn bolt (6) from nut (7). WARNING