TM-9-2320-366-10-1 MTV Operator Manual M1083 Series - Volume 1 Download
Page 122 of 802
TM 9-2320-366-10-1 1-21. M1084/M1086 MATERIAL HANDLING CRANE (MHC) (CONT) Figure 1-26. Material Handling Crane (MHC) (Cont) c. Control Levers and REMOTE CONTROL UNIT. All control levers (13) are spring- loaded and will return to the center position when released. Moving the lever slightly from the center position results in a slow movement of the function which that valve controls. Moving the lever further from the center position results in a faster movement. The function of each control lever is identified on the end of the control knob (14). The MHC REMOTE CONTROL UNIT (15) allows you to operate the MHC from either side of the vehicle. This means that you can keep the load in sight at all times. A remote control switch (16) switches power to the REMOTE CONTROL UNIT. The REMOTE CONTROL UNIT is attached to the MHC by a cable (17). The MHC responds to the remote control levers the same as it does to the levers at the control panel. The levers on the REMOTE CONTROL UNIT are also spring-loaded and will return to the center position when released. The REMOTE CONTROL UNIT has levers to operate hoist up/down, boom up/down, boom telescope in/out, and swing clockwise/counterclockwise. 1-70