TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 995 of 1414
TM 9-2320-365-34-2 NOTE Approximate depth of thread engagement is 0.375 in. (9.525 mm). If puller assembly will not engage to this depth, continue to cut threads until this depth is achieved. (27) Apply sealing compound on threaded stem of puller assembly (16). (28) Install puller assembly (16) into injector sleeve (11). (29) Install reaction sleeve (17) and plate (18) over threaded stem of puller assembly (16). (30) Position thrust bearing (19) on plate (18). (31) Position washer (20) on thrust bearing (19). (32) Install nut (21) on threaded stem of puller assembly (16). CAUTION Stop pulling on injector sleeve when it pulls free from lower bore. Manually lift puller assembly enough to center injector sleeve in upper bore before using wrench to pull injector sleeve through upper bore. Failure to center injector sleeve in upper bore may result in damage to cylinder head or tool. NOTE Upper bore in cylinder head is small enough that injector sleeve must be pulled through that bore also. (33) Remove injector sleeve (11) from cylinder head (1). (34) Remove nut (21), washer (20), thrust bearing (19), plate (18), and reaction sleeve (17) from puller assembly (16). (35) Remove injector sleeve (11) from puller assembly (16). 20-9