TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 948 of 1414
TM 9-2320-365-34-2 18-40 Change 2 18-4. DIGITIZATION KIT INITIAL INSTALLATION (CONT) (74) Apply sealant to three of four screws (83). (75) Install EPLRS shelf (84) and inside support (85) on support legs (73) with four washers (86) and screws (83). Refer to Table 18-1 for hole locations. (76) Position outer side support (87) on inner side support (85) with three washers (88), screws (89), and self-locking nuts (90). (77) Position rear and mid support (91) on EPLRS shelf (84) with three washers (92), screws (93), and self- locking nuts (94). (78) Position six washers (95), screws (96), and self- locking nuts (97) in support legs (73). (79) Tighten three self-locking nuts (94 and 97) to 110- 120 lb-in (12-14 N•m). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel.